Crawler Color Sorter Machine Structure and Function

2022-03-14 00:00

All parts of this machine that come into contact with the selected materials are made of stainless steel or non-toxic metal materials. Its basic structure is shown in Figure 4-1.

        All parts of this machine that come into contact with the selected materials are made of stainless steel or non-toxic metal materials. Its basic structure is shown in Figure 4-1.

Figure 5-1 Model structure diagram

5.1 Feeding hopper

The bucket that gathers raw materials provides raw materials for color sorting.

5.2 Vibrating feeding device

It consists of a vibrator and a feeding hopper. After the raw materials fall into the feeding hopper, they are vibrated by the vibrator and evenly transported to the channel.

The size is controlled and adjusted by the electrical box to achieve control of the feeding amount of the whole machine.

5.3 Channels

It consists of a set of inclined slides and fastening frames, which can arrange the selected objects in an orderly manner so that they can be recognized by the camera in the sorting box.

5.4 Touch Screen

The intelligent control center of the machine can complete the color sorting parameter setting, color sorting start and stop control, etc. through the touch screen.

5.5 Power switch

Start and stop control of the whole machine power.

5.6 Electrical control box

Fully sealed box. The control system mainly consists of a microcomputer and FPGA, which is the control core of the machine. This system is responsible for automatic

Collect, amplify and process photoelectric signals, and the controller sends out instructions to drive the spray valve to spray compressed air to blow out the rejected objects to complete color sorting.

function to achieve the purpose of selection.

5.7 Front and rear sorting boxes

It consists of a light source, a background device, a CCD lens device, and a dust removal device. When working, the CCD lens device sends the received information to the FPGA system for processing. The dust removal device automatically removes dust from the glass of the sorting box at a fixed time so that the sorting is not disturbed by dust.

5.8 Gas system

It is equipped with a ball valve, air filter, dust filter, pressure gauge, pressure regulating valve, etc. to provide highly clean compressed air to the whole machine.

5.9 Front and rear hoppers

It is divided into front and rear chambers, which receive the finished products and rejected materials of the first and second sorting respectively. In addition, there is a dust suction port on the side of the receiving hopper.

The interface diameter is Φ100mm, and the dust suction port is made of metal, which is required to be prepared by the user.

5.10 Spray valve device

The high-speed electronically controlled jet device sprays compressed air at the right time to blow out the rejected objects when receiving the execution command.

5.11 Heating device

Located at the back of the channel, it is controlled by the air switch and automatic temperature control system in the electrical box to maintain the channel temperature at around 40℃.